PowerDyne Bearing Press and Puller

Installing or replacing your bearings is a cinch with the PowerDyne Bearing Press and Puller. 

PowerDyne Bearing Press and Puller Features:

• Helps to remove and insert bearings into wheels
• Mounting holes allow you to attach Press/Puller to a solid base
• Designed to specifically work with 8mm bearings.  7mm adapter can be purchased. 
• Replacement Puller Parts available.

To use the PULLER, start with the handle up and the long pin down (sideways). Then put the wheel on the outside, push the handle down, and pull the bearing out. Repeat to pull out the other bearing.

To use the PRESS, stand the pin up and put a bearing down on the pin. Next, put the wheel with the outside of the wheel (usually the printed side) facing up and put another bearing on the pin. Tip the pin down (sideways) and carefully pull the handle down. You may have to guide the bearings a bit to get started. The aluminum-hub wheels may be a bit trickier than the nylon-hub or no-hub wheels. Do not use excessive force. A very small amount of silicone oil around the outside of the bearing usually helps ease them into the aluminum-hub wheels.